How to attach your hanging wire
Once you've selected your wire, cut a piece 8-12" longer than the horizontal width of your artwork. This will ensure you have plenty of wire for wrapping.
1.Thread one end of the wire through the ring of the hanger, going from over top to bottom.
2.Pull through 4-6", then crimp the wire around the ring. Take the short end of the wire over the long end, and pass it through the ring again, this time from bottom to top.
3.Slip the short end of the wire through the loop created above the long end and pull tightly to make a slipknot.
4.Coil the rest of the short end around the long end.
5.Draw the wire across the frame and insert it through the other ring. Crimp the wire around the ring and hold firmly.
6.Pull the wire up slightly in the center of the frame. There should be enough slack that the tip of this "triangle" is a few inches closer to the top of the frame than the hangers. In most cases, this center point will be about halfway between the top of the frame, and the hangers.
7.Repeat steps 2-4 for the second ring.
