- Fresh Gel Toilet Bowl Cleaning Stamps
To Apply:
Apply to a clean toilet.
- Snap: Slide the two pieces together so that the button on the Gel Tube snaps into the first hole on the blue Handle.
- Place: Remove cap and position end of Gel Tube near the rim on inside of bowl.
- Push: Press and hold button down while pushing unit towards the bowl. When button clicks into the next hole, pull unit back to leave a gel stamp.
- Cap: Replace cap securely and store.
- Refill: After dispensing the last gel stamp, remove Gel Tube from Applicator. Keep Applicator for refill.
Retain outer packaging for full use and safety instructions
- Antibacterial Bathroom Flushable Wipes
To Open Resealable Pouch: Open pouch by peeling back seal, then pull up wipe through hole. Use wipes to clean surfaces such as sinks, counters, glazed tile and outside toilet surfaces including seats, rims and tanks. When wipe gets dirty or dries out, discard in toilet bowl and flush (or discard in trash). Never flush more than one wipe at a time. Never flush when other matter is present in bowl. If used on toilet seat, allow to dry before sitting. Do not flush if plumbing system is not working optimally. Reseal pouch after each use to retain moisture. Store in a cool location.
Directions For Use: It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
To Clean And Deodorize: Wipe surface clean and allow to air dry.
To Sanitize Hard Non-Porous Surfaces: Wipe surface. Use more than one wipe, if necessary, so the surface stays visibly wet for 1 minute. Allow surface to air dry. For highly soiled surfaces, clean off excess dirt before sanitizing.
Won't Harm Septic Systems! Scrubbing Bubbles Antibacterial Bathroom Wipes are flushable and disperse in water when agitated, just like toilet paper, so you don't have to worry about your plumbing. Just grab, wipe, and flush the mess away!
